SGS-800-12..Gas Spring Pneumatic Lid Stay. 26 lbs closing Strength. For lift up lids and for drop down lids. Assist some in opening of lid but needs pressure applied to close. Use two and double the closing strength. Similar in operation to those used on hatchback cars. When installed you must push/pull down the lid to close. Resistance of stay lessens as it gets closer to closing. Lid stay in photo is in the open position and is almost impossible to close until installed and all SGS800 lid stays are the same size, just the strengths are different. We recommend using two stays on lids longer than 36 inches. As a general rule when using two stays then you would cut the weight factor in half, for instance a 44b lid could be supported by two 22 pound rated stays. Length and width is a variable which may affect choosing a stronger or weaker stay. Length of the stay shown in this photo is 11-3/4″ long in the open positions without the footed attachment. It approximately 7-1/2 inches long in the closed position. Good quality stay. Sold individually.
PNEUMATIC GAS SPRING LID STAY SGS-800-12
$12.95
In stock
Be the first to review “PNEUMATIC GAS SPRING LID STAY SGS-800-12” Cancel reply
Related products
Desk Hardware and Accessories
ROLL TOP DESK LOCK 2 KEYS AND LOCK PLATE PLATE NO KEY HOLE COVER BM-6550
$18.95
Antique Trunk Hardware and Steamer Trunk Parts
$12.95
Antique Trunk Hardware and Steamer Trunk Parts
$12.95
Desk Hardware and Accessories
DESK DROP FRONT FLAP HINGE IN NICKEL FINISHED METAL. SOLD EACH H-32435N
$7.50
Desk Hardware and Accessories
DESK DROP FRONT FLAP HINGE IN BRONZE FINISHED METAL. SOLD EACH NOT PAIRS H-32435L
Rated 5.00 out of 5
$7.75Antique Trunk Hardware and Steamer Trunk Parts
Rated 5.00 out of 5
$16.95
Reviews
There are no reviews yet.